Filter
Top Products
WattMaster WHP Section 3
Programming 3-3
System Manager LED Indicators
There are two LED indicators located on the right hand side of the System Manager.
The top LED indicates an Alarm condition if the Manager detects an alarm condition
while polling the system.
The bottom LED is active during actual communications or packet transfers. This LED
will normally “flicker” and not remain on constantly.
Main User Menu
1) View Status Only For quick access to an
individual heat pump or the
loop controller, select this menu
item. No passcode is required to
access the status of any unit
installed on your system.
2) View Alarms If the System Manager has been
configured for Alarm Polling,
the user can select this item to
get a list of unit addresses that
are currently in alarm. If an
alarm exists, the Alarm LED
will be active on the right side
of the panel.
MENU) Setpoints If you are a Level 2 user, all system
setpoints are available to you.
These setpoints are accessed via
this Menu button.
ESC) Main Screen When you have finished viewing
the system you can exit this menu
and return to the Main Screen by
pressing the ESC button.