Filter
Top Products
Ð 99 Ð
SCAN LOG BY PART
0=NO 1-2=PART #
The system allows viewing of any partition's event log.
Enter the partition number for the partition whose events
are to be displayed. Entering 0 (NO) will display all events
that occurred in the system regardless of partition.
For display purposes, events are stored on a partition by
partition basis (except system events), and are grouped
into five categories as follows.
Use the [3] & [1] keys to scroll to the next or previous category screens
respectively:
ALARM EVENT LOG
TYPE CCC UUU
Displays time/date for zones that have either caused an
alarm or have been restored in selected partition.
CHECK EVENT LOG
TYPE CCC UUU
Displays time/date for zones that have caused a trouble or
supervisory condition in selected partition.
BYPASS EVENT LOG
TYPE CCC UUU
Displays time/date for zones that have been bypassed in
selected partition.
OP/CL EVENT LOG
TYPE CCC UUU
Displays time, date and user number for each arming and
disarming of the system for the partition selected. Note
that only those users enabled by the installer during
"add a user" procedure will be logged.
SYSTEM EVENT LOG
TYPE CCC UUU
Displays time/date for system problems, such as AC
Loss, communication failure, etc., regardless of partition.
ALL EVENT LOG
TYPE CCC UUU
Displays all categories of events in chronological order,
from most recent to oldest.
To display the events in a particular category, press [8] at the desired
category screen.
If in Display Mode, events will appear one at a time from the most recent to the
oldest. Use the [1] key to display events backward in time (from recent to past).
Use the [3] key to display events forward in time. The following is a typical display:
P2 01/01 12:02AM
BURGLARY C03
Shows burglary alarm occurred in zone 3 of partition 2, at
12:02AM on January 1.
After the last event in the selected category has been displayed, the system will
automatically return to the next event category screen.
Clear Event Log To clear the Event Log, enter installer code + [#] + [6] + [2]
The following will appear:
CLEAR EVENT LOG
0=NO 1=YES
Press [1] if Event Log is to be cleared from memory. All events in the log will still
be displayed if the COMPLETE option is selected. Only those events occurring
from the time of the CLEAR command will be displayed if RECENT display option
is selected. Press [0] if event log is not to be cleared at this time.
If [1] is pressed, the following will appear:
ARE YOU SURE?
0=NO 1=YES
Press [1] if it is desired to clear the event log. Press [0] if event log is not to be
cleared.
Screen Definitions
RECENT Events since last CLEAR
COMPLETE Displays all events
TYPE Type of event (Burg., Fire, etc.)
CCC Zone (contact) number
UUU User number