Filter
Top Products
Important Safety Information
3
1. READ AND FOLLOW ALL
INSTRUCTIONS. Failure to meet the
requirements set forth in the instruction manual
could cause severe injury and/or death, for which
the manufacturer cannot be held responsible.
2. When designing a system that will be entered
from a highway or main thoroughfare, make sure
the system is placed far enough from the road to
prevent traffic congestion.
3. The gate must be installed in a location that
provides adequate clearance between it and
adjacent structures when opening and closing to
reduce the risk of entrapment. Swinging gates
must not open into public access areas.
4. The gate and gate opener installation must
comply with any applicable local codes.
I. Before Installation
1. Verify this opener is proper for the type and size
of gate, its frequency of use and proper class
rating.
2. Make sure the gate has been properly installed
and swings freely in both directions. Repair or
replace all worn or damaged gate hardware prior
to installation. A freely moving gate will require
less force to operate and will enhance the
performance of the opener and safety devices
used with the system (see page 10).
3. Review the operation of the system to become
familiar with its safety features. Understand how
to disconnect the opener for manual gate
operations (see page 2).
4. This gate opener is intended for vehicular gates
ONLY. A seperate entrance or gate must be
installed for pedestrian use (see page 7).
5. Always keep people and objects away from the
gate and its area of travel. NO ONE SHOULD
CROSS THE PATH OF A MOVING GATE.
6. Pay close attention to the diagram below and be
aware of these areas at all times.
For the Consumer
WARNING: To reduce the risk of injury or death:
Gate in the
Open Position
ZONE 2
ZONE 3
ZONE 4
ZONE 5
Driveway
ZONE 1
Entrapment
Zones for a
Push-To-Open
Application
Gate in the
Open Position
ZONE 2
ZONE 3
ZONE 4
ZONE 5
Driveway
ZONE 1
Entrapment
Zones for a
Pull-To-Open
Application