GTO UL325 SERIES Garage Door Opener User Manual


 
Column Installation Information
Before You Begin
3/8” x 1-1/4” Clevis Pin (2)
RB500
12 Volt
/
7.0 Amp Mount
Installation Overview for the...
3/8” x 8” Bolt (4)
8” Nylon Cable Tie (14)
Receiver and
Control Box
Operator
Arm
Gate Bracket
Post Pivot Bracket
Post Brackets
Transformer Warning
Sign
Closed Position
Bracket
Transmitter
Installation
Video
Battery
3/8” x 2” Bolt (1)
5/16” x 1-3/4” Bolt (1)
3/8” Washer (9)
3/8” Lock Washer (7)
5/16” Lock Washer (1)
5/16” Washer (1)
3/8” Nut (7)
5/16” Nut (1)
Hairpin Clip (2)
2” Mounting Screw (5)
1. KEEP CLEAR! Gate may move at any time.
2. Do not allow children to operate gate or
play in gate area.
3. This gate is for vehicles only. Pedestrians
must use a separate entrance.
Moving Gate Can Cause
Injury Or Death
WARNING
!
1. KEEP CLEAR! Gate may move at any time.
2. Do not allow children to operate gate or
play in gate area.
3. This gate is for vehicles only. Pedestrians
must use a separate entrance.
Moving Gate Can Cause
Injury Or Death
WARNING
!
Installation Overview for the...
A
H
I
K
F
B
G
D
C
J
E
L M
Q
W
S
R
O
N
P
T
V
U
X Y Z
3/8” Bushing (2)
3/8” x 3” Bolt (2)
A. The simplest solution is to install the opener in a
push-to-open configuration (requires push-to-open
bracket, see accessory catalog). The minimum
clearance is easier to achieve and clearance is no
longer a problem, since the opener will be pushing
the gate away from the column instead of pull-
ing it toward the column. It is recommended that
you place a steel plate between the opener mount-
ing brackets and masonry surface for additional
strength.
B. If a push-to-open installation is impossible due to
traffic hazards, terrain, etc., another option is to
re-hang the gate. You may hang it on a post, either
in the center of the column or at the back corner, or
move the gate to the back corner of the columns.
C. The most difficult solution is to cut a notch in the
column to accommodate the opener and power
cable. This job is NOT for the inexperienced!
IF THIS OPENER WILL BE USED WITH GATES THAT ARE MOUNTED ON MASONRY, BRICK,
OR ROCK (etc.) COLUMNS, READ THE FOLLOWING CAREFULLY BEFORE PROCEEDING
Column
Pivot Bracket
Gate
A
B
Column Mount Example
(A + B can not exceed 14 inches)
Example: If A is 2" then B can not exceed 12"
Hinge
11
Items Included