Filter
Top Products
REPLACING THE NEEDLE
The presser foot pressure of the machine
has been pre-set and requires no particular
readjustment according to the type of
fabric (light-or-heavy weight).
However, if you need to adjust the presser
foot pressure, turn the presser adjusting
screw with a coin.
For sewing very heavy fabric, tighten the
pressure by turning the screw counter
clockwise, and for thin fabric, loosen by
turning it clockwise.
Change the needle regularly, especially if it
is showing signs of wear and causing
problems.
Insert the needle following the illustrated
instructions.
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle. The flat side of the shaft should
be towards the back.
B. Insert the needle as far up as it will go.
Needles must be in perfect condition.
Problems can occur with:
- Bent needles
- Blunt needles
- Damaged points
A
B
ADJUSTING PRESSER FOOT PRESSURE
Attention:
Turn power switch to off ( when carrying
out any of the above operations!
"O")
20
02