Filter
Top Products
5. Then, down and around the check spring holder.
6. At the top of this movement, pass the thread from right to
the left through the slotted eye of the take-up lever and
then downwards again.
7. Pass the thread behind the flat, horizontal thread guide.
4. Thread the tension module by passing the thread between
the silver discs.
9. Pull the end of the thread through the needle from front to
rear, and pull out about 10 cm of thread.
Use the needle threader to thread the needle. (On the next
page.)
8. Guide the thread through the wire loop.
THREADING THE UPPER THREAD
17
02