Filter
Top Products
When inserting or removing the bobbin, the needle must
be fully raised.
1. Insert the bobbin in the bobbin case with the thread running
in a counterclockwise direction (arrow).
2. Pull the thread through the slit (A).
3. Pull the thread toward the left and along the inside of the
spring until it slips into the notch (B) being sure that the
thread does not slip out of the slit (A).
4. Pull out about 15 cm (6 inches) of thread and attach the
bobbin cover plate. (C)
A
B
B
A
C
INSERTING THE BOBBIN
Attention:
Turn power switch to off ("O") before inserting or removing the
bobbin.
15
02