Filter
Top Products
5. When the closing stop point or limit switch is reached, the motor pauses for approximately 2
seconds, and then restarts with a total opening maneuver to the opening stop point or limit
switch.
6. When the full open stop or limit switch is reached the doors will stop.
7. Wait for the amount of time you would like your doors to pause for during normal operation
before automatically re-closing and then signal your opener using an OPEN A contact or trans-
mitter signal to close the doors. The doors will then return to closed and programming will be
complete.
(Even if your auto close is off you must still set a pause time, the pause time
will not be used in normal door operation.)
5.5
Dual doors are programmed
simultaneously. Move both
of the leafs to the same
starting position and both
leafs will move together
through the same
programming sequence.
There is a slight starting
delay on the slave side.