Filter
Top Products
20% of total arch
10% of total arch
SOFT
START/
STOP
This parameter determines when the door will
begin to slow down near the end of opening
and closing cycle.
Low
High
SOFT
SPEED
This parameter determines how fast the door
will move during the soft start/stop. If using
positive stops this parameter must be on 0.
No Limit Switch
Limit Switch
LIMIT
SWITCH
In this parameter you MUST specify whether
you are using limit switches or not for proper
function of your door.
Single Leaf Door
Dual Leaf Door
SINGLE
OR DUAL
In this parameter you MUST specify whether
you are using single door (one leaf - one
motor) or dual door (two leaves - two motors).
After programming your last parameter you may now move on to
programming your door run time. Press P2 one more time to exit this
mode. Door movement instructions begin on the next page.
5.3