Filter
Top Products
Installation of Operator
The operator base plate and articulated arm are designed either for right-handed or
left-handed installation. There is no pre-determined designation.
1. Begin with your gear motor in the base plate. Hold the base and motor against the Wall
above the door and find the proper position for your operator (from previous page). Mark
the outline of the base plate with the operator in the correct position. Then remove the mo-
tor from the base plate.
2. Secure the base plate to the wall using screws and a proper anchoring system for your type
of wall or frame material. Example below is looking at the door from inside the garage.
3. Fit the gear motor back onto the base plate and secure it with two screws, nuts and wash-
ers.
Important: The transmission shaft must always face downward.
Continued on next page.
3.3
Transmission shaft
L
R