Filter
Top Products
Tools Needed
Other items that may be needed prior to commencing installation.
• Start and stop post, bracket or door stop. Although the Estate Swing E-SC 1602 features
soft start/stop and can be used with limit switches (not included), it is possible to use the
E-SC 1602 without limit switches, relying on the positive stops to determine end posi-
tions.
• 16, 14 or 12 gauge, 2 conductor stranded direct burial low voltage wire will be re-
quired to run power to your operator. Length is determined by distance between trans-
former power supply and the control box.
• A voltage meter and digital camera may be necessary to run diagnostic checks.
• 4 - 3/8” Red Heads, Lag Screws and Shields, or another brand wall mounting 3/8”
bolt and anchor will be needed to connect the Base Plate to the wall.
• 2 - 5/16” Hex Bolts will be needed to connect the Door Mounting Bracket to the door.
Length will be determined by what is needed for a secure anchor.
• If your transformer is going to be plugged into an outdoor outlet you will need to weather-
proof that outlet and transformer. Electrical boxes or plug covers can be obtained from a
local hardware store to accommodate both the plug and transformer.
• Hardware to attach the control box to a wall.
• Watertight connectors for running wires into the control box.
1.4
• Power Drill and appro-
priately sized bits.
• Crescent Wrench
• Flat Head Screwdriver
• Nuts, Bolts, Anchors
and Washers (see below)
• C-Ring Pliers
• Phillips Head Screw-
driver
• Tape Measure
• Level
• Wire Strippers
• C-clamps
• Carpenters Clamps