Filter
Top Products
4.7
Installing and Setting Transmitters and Receivers
Installing the Receiver
1) Locate the 5 Silver Pins in the lower right hand corner of the Estate Swing board.
2) Locate the white connector on the receiver.
3) Push the white connector
from the receiver on the 5
pins on your control board
with the dip switches of the
receiver board facing away
from the Estate Swing
board.
Setting the Dip Switches
1) Set the dip switches 1-9 on the receiver by switching them in the up or down position.
Record this dip switch combination
2) Slide off the battery cover of the transmitter (located at the bottom front cover)
3) Set the dip switches in the transmitter to the same settings as the dip switches on the
receiver.
4) Repeat this for all of the transmitters.
.
Dip switches are located under
the battery lid.