Filter
Top Products
MODEL 54eA SECTION 5.0
SOFTWARE CONFIGURATION
FIGURE 5-1. Menu Tree for the 54eA Controller (continued)
Display (see page 22)
Outputs (see page 22)
Alarms (see page 22)
Program
Calibrate (see page 21)
Diagnostic Variable (see page 21)
Main
Menu
Alarm Setpoints (see page 22)
Output setpoints
(see page 22)
Simulated tests
(see page 22)
Configure
pH
(available with free
chlorine only)
Disable
Enable
pH
diagnostics
Diagnostics: on or off
Glass impedance high
Glass impedance low
Zero offset
Impedance temp comp: on or off
Temperature
Temperature comp: auto or manual
Units: °C or °F
Noise
Rejection
Noise rejection: 50 or 60 Hz
Barometric
Pressure
Measurement: Auto or manual
Units: mm Hg, kPa, atm, barg, in Hg
Main sensor cal
Stabilize conc’n
Stabilize time
Salinity (oxygen only)
Security
pH
calibration
Autocal: standard, manual,
Merck, Ingold, DIN 19267
Stabilize pH
Stabilize time
Temperature
coefficient
Temperature coeff
Operating isopotential
Sensor isopotential
Lock all
Lock program
Lock configure
(oxygen only)
23