Filter
Top Products
10-11
Rosemount Tank Radar REX
Chapter 10 Mechanical Installation
Installation Manual
308014EN, Edition 4
May 2013
10.2.5 Mounting the Flange Ball model T30
1 Use a flange which is 6 - 30
mm thick. Make sure that the
diameter of the hole is 96 mm.
Make a small recess at one
side of the flange hole.
2 Put the O-ring on the flange
and insert the Flange Ball into
the flange hole. Make sure that
the pin on the side of the
Flange Ball fits into the corre-
sponding recess on the flange.
3 Tighten the nut so that the
Flange Ball fits tightly to the
flange (torque 50 Nm).
Recess
10.1.eps
Flange Ball
Nut
10.2.eps
10.3.eps