Filter
Top Products
www.desatech.com
117437-01B 17
Figure 28 - Removing Louver Panel
Louver
Panel
Spring
Latch
Removing/Replacing Glass Door
WARNING: Handle glass
door panel with care. Do not
strike, slam or otherwise abuse
glass. Do not operate fire-
place with glass door removed,
cracked or broken.
If replacement of glass is necessary, the entire
assembly, glass and frame, must be replaced. If
glass is broken, wear gloves and tape the remaining
fragments onto the frame.
1. Placing a screw driver or your nger tips into
the gap between lower glass panel rail and
bottom face frame, lift glass door assembly
until door pins clear locating holes in bottom
face frame (see Figure 29).
2. Swing bottom glass panel assembly out until
door pins on lower rail clear bottom face frame
(see Figure 30).
3. Lower door down until upper door pins are
free of locating holes in spring clips and place
in a safe area.
4. Replace glass panel in reverse order by insert-
ing top door pins into spring clips, lifting up
at lower frame rail and locating bottom pins
in holes on lower face frame.
FIREPLACE INSTALLATION
Continued
Figure 30 - Removing/Replacing Glass
Door
Spring Clips
Glass Panel
Frame Rail
1. Lift Up Panel
at Lower Rail
Figure 29 - Removing/Replacing Glass
Door
Locating
Hole
Door Pin
Glass Panel
Frame Rail
2. Swing Out
Panel
3. Lower
Panel Out
Removing Louver Panels
Remove the top and bottom louver panels by si-
multaneously pulling both top end spring latches
towards the center of the appliance until they are
disengaged from the locating holes (see Figure 28).
Repeat for bottom spring latches and pull the lou-
vers outward. To install or replace items removed,
simply reverse the procedures above.