Filter
Top Products
www.desatech.com
115254-01A
20
Figure 30 - Installing Rear Log (#3)
Figure 31 - Installing Crossover Log (#4)
INSTALLING LOGS
Models (V)L36(ZNR, LZNR, ZPR, LZPR)
and (V)L42(ZNR, LZNR, ZPR, LZPR)
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
Each log is marked with a number. These numbers
will help you identify the log when installing. It
is very important to install these logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
Note:
Your appliance may vary from model shown
but log placement will be the same.
1. Place ember bed in center of the base assembly
as shown in Figure 32.
2. Rest rear log in back corner sections of base as
-
sembly as shown in Figure 32. Make sure log is
completely vertical and not leaning in toward
burner where the flame will touch the log.
3. Position middle log as shown in Figure 32
making sure the grooves in the bottom of the
log fit over the grate prongs. This log will rest
on top of the bottom log.
Base
Assembly
Figure 32- Installing Ember Bed, Rear
and Middle Logs
Ember
Bed
Rear Log
Middle Log
3. Slide groove on back of rear log against the rear
grate prongs. Make sure the peg on the log is
on top (see Figure 30).
4. Place the crossover log on the rear and middle
logs. Make sure peg on rear log is in the hole in
bottom of crossover log. The crossover log should
fit in cutout of middle log (see Figure 31).
INSTALLATION
Continued
Rear Log
(#3)
Rear
Grate
Prong
Crossover
Log (#4)
Peg
Figure 29 - Installing Center Log
Center Log (#2)
Grate
Metal Post
Metal
Post