Filter
Top Products
www.desatech.com
115254-01A 19
INSTALLING LOGS
(Models (V)L32HN, (V)L32LHN.
(V)L32HP
and (V)L32LHP
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
Vintage Oak Two-Piece Log Set
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place front log on top of the grate and over front
posts on chassis (see Figure 26).
Front Post
Figure 26 - Installing Vintage Oak Two-
Piece Log Set
Figure 27 - Installing Vintage Oak Two-
Piece Log Set (Top View)
Two Piece Log Set
Burner Ports
Log #2
Chassis
Rear
Post
Log #1
INSTALLING LOGS
Models L36(EN, LEN, EP, LEP) and
VL36(EN, LEN, EP, LEP)
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use logs
supplied with heater.
Note: Your appliance may vary from model shown
but log placement will be the same.
1. Place front logs (1L and 1R) on top of grate.
Make sure notches in bottom of logs fit over
grate prongs (see Figure 28).
2. Rest bottom of center log (#2) behind metal
posts on front burner (see Figure 29, page 20).
Make sure grooves in bottom of log fit over
grate. Bring log forward against metal posts.
INSTALLATION
Continued
Figure 28 - Installing Front Logs
Front Logs
Notch
Grate
Prong
2. Place rear log on rear of chassis (see Figure 26).
Slide log forward so that it sits against rear posts
on chassis. IMPORTANT: Make sure logs do
not cover any burner ports (see Figure 27).
3. Place lava rock around base of heater if desired.