Desa L32, L36 L36, L42, L32, L36, L36, L42 Indoor Fireplace User Manual


 
www.desatech.com
115254-01A 13
INSTALLATION
Continued
INSTALLING OPTIONAL BLOWER
ACCESSORIES
NOTICE: The firebox identifica-
tion label (including model num-
ber, serial number, clearances,
etc.) is located in the right side
screen pocket area on the front
of the firebox. See Figure 25,
page 15.
NOTICE: If a log set is installed
in the firebox, disconnect log
set from gas supply and remove
from firebox. Contact a qualified
service person to do this.
Note: Appearance of firebox may vary depending
on model.
The blower accessory option for use in the vent-
free fireboxes is model BK. Model BK is a rotary
squirrel cage type blower with magnetic attach
-
ment and variable speed control.
The blower is installed by removing the lower face
panel. To remove the lower face panel, pull the left
and right latches toward the center of the appliance
until they are disengaged from their locator holes
(see Figure 12).
Models with louvered front panels can also be
removed by inserting fingertips between slots
and gently pulling out. DO NOT FORCE. The
panels are actually held in place by means of a
retention dimple embossed on the edge of remov
-
able panels.
WARNING: If there is a duplex
electrical outlet installed in the
right side of the bottom of the
fireplace base area (see Figure
13), be sure that the electrical
power to the outlet is turned off
before proceeding with blower
installation. Failure to do this
may result in serious injury.
1. Attach the power cord to the blower motor by
firmly pushing the two female terminals at the
end of the power cord onto the two spade ter-
minals on the blower motor (see Figure 14).
Figure 12 - Accessing Blower
Compartment (Controls Not Shown
for Clarity)
Lower
Louver
Panel
Duplex Electrical Outlet
Figure 13 - Accessing Duplex Electrical
Outlet Installed in Bottom Right Side of
Firebox
Figure 14 - Blower Model BK
Magnetic Strips
Exhaust
Port
Screw
Green
Ground
Wire
Spade
Terminals
Side View
Firebox Bottom
Air Flow
Direction
Blower
Installed
After
Lower
Panel
Removed
Blower
Location
Magnets