Filter
Top Products
Programming
Your garagedoor openerhas been programmed at the factory to operatewith your remote control. The remote control can be
programmed using the door control or the garagedoor opener.To program additional remote controls refer to the instructions provided
with the additional remote controls.
PROGRAMA REMOTEUSINGTHE LEARNBUTTON TOADD, REPROGRAM,ORCHANGEA REMOTECONTROL/
KEYLESSENTRYPINUSINGTHESMARTCONTROLPANEL
1. Pressand releasethe Learn
button on the garagedoor opener.The
Learn indicator light will glow steadily
for 30 seconds.
2.Within 30seconds, press and hold the
button on the remote control.
1. Pressthe navigation button below
"MENU"to view the Featuresmenu.
2. Usethe navigation buttons to scroll to
"PROGRAM"and press the navigation
button under_ to continue.
3. Releasethe button when the garage
door opener light blinks. It haslearned
the code. If light bulbs are not installed,
two clicks will be heard.
When replacingthe light lenscover, ensure the antenna wires are
hanging straight down.
3. Select "REMOTE"or "KEYPAD"to
program from the program menu.
Press_ to continue.
4. Pressthe button on the remote
control that you wish to operate your
garagedoor.
OR
Entera 4-digit personal identification
number (PIN) of your choice on the
keyless entry keypad.Then press the
ENTERbutton.
OR
? ? ? ?
PIN
To Erase the Memory
ERASEALLREMOTECONTROLSAND KEYLESSENTRIES
1. Pressand hold the learn button on garagedoor opener until the
learn LEDgoes out (approximately 6 seconds). All remote
control and keyless entry codes are now erased.
Reprogram anyaccessory you wish to use.
ERASEALLDEVICES
1. Pressand hold the learn button on garage door opener until the
learn LEDgoes out (approximately 6 seconds).
2. Immediatelypress and hold the learn button again until the
learn LEDgoes out. All codes are now erased.
Reprogramany accessoryyou wish to use.
34