Filter
Top Products
Features(Continued)
USINGYOURGARAGEDOOROPENER
The garagedoor opener can be activatedthrough a wall-mounted
door control, remote control, wireless keyless entry or
AssureLinkTM accessory.
When the door is closed andthe garagedoor opener is activated
the door will open. If the door senses an obstruction or is
interrupted while opening the door will stop. When the door is in
any position other than closed and the garage door opener is
activated the door will close. If the garage door opener sensesan
obstruction while closing, the door will reverse.If the obstruction
interrupts the sensor beamthe garagedoor opener lights will
blink 10 times. However,you can close the door if you hold the
button on the door control or keylessentry until the door is fully
closed.The safety reversing sensorsdo no effect the opening
cycle.
Thesafety reversing sensor must be connectedand aligned
correctly before the garagedoor opener will move in the down
direction.
Door Control
USINGTHE DOORCONTROL
Push Bar
Navigation
Buttons
LIGHT
Button
Screen
Motion
Sensor
Push Bar
Pressthe push bar to open or close the door.
LightButton
Pressthe LIGHTbutton to turn the garagedoor opener lights on
or off. When the lights areturned on they will stay on until the
LIGHTbutton is pressedagain, or until the garage door opener is
activated.Oncethe garagedoor opener is activatedthe lights will
turn off after the specified period of time (the factory setting is
4-1/2 minutes). The LIGHTbutton will not control the lights when
the door is in motion. Theduration of the light timing can be
adjusted using the door control.
NavigationButtons
Usethe navigation buttons to make selections and program
features.
Screen
Thescreen will display the time and temperature until the menu
button is pressed, andthen it will display the menu options. If
there is a problem with the garagedoor opener the screen will
display the Diagnostic Code.Referto the Troubleshooting section.
The followingfeaturesare accessiblethroughthe screenusing
the navigationbuttonsonthe SmartControlPanel:
LEARNA DEVICE
Any compatible remote controls, wireless keylessentry, or
AssureLinkTM accessories can be programmed to the garagedoor
opener by accessing the menu and using the navigation buttons
on the Smart Control Panel.
Lock
The LOCKfeature is designedto preventactivation of the garage
door opener from remote controls while still allowing activation
from the door control and keylessentry. This feature is useful for
added peaceof mind when the home is empty (i.e. vacation).
Timer-to-Close(TTC)
DONOTenableTTC if operating a one-piecedoor. TTCis to be
used ONLYwith sectional doors.
Factory default is set to off. TTC canbe set to automatically close
your garagedoor from the fully open position after a specified
period of time (1, 5, 10 minute intervals). TheSmart Control Panel
also has a custom setting up to 99 minutes. Thegarage door
opener will beep and the lights will flash before closing the door.
Thescreen on the door control will display the status of the TTC
such astime to close, paused,or an error. If the door encounters
an obstruction while closing, the garagedoor opener will make a
second attempt to close the door. If the obstruction has not been
clearedafter the second attempt, the garagedoor opener will
reverse open,stop and WILL NOTclose until the obstruction has
been cleared.TTCWILL NOTwork if the garage door opener is
operating by battery power or if the safety reversing sensorsare
misaligned. This feature is NOTintendedto be the primary
method of closing the door. Akeyless entryshouldbe installed
in the eventof an accidental lockoutwhen usingthis feature.
AUTOMATICLIGHT
Motion Sensor
Factory default is set to on. This feature will automatically turn on
the garagedoor opener lightswhen motion is sensed.The lights
will come on for the set period of time, then shut off.
The lightswill turn on when someone enters through the open
garage door and the safety reversing sensor infrared beam is
broken.
If using the garagedoor opener light as a work light disablethe
Automatic Light Feature,otherwisethe light will turn off
automatically if you are beyondthe rangeof the sensor.
32