Filter
Top Products
INSTALLATION STEP 1 1
Install the DoorControl
INTRODUCTION
NOTE:Older Craftsmanaccessories and third party products are
not compatible.
Your garage door opener is compatible with up to 2 door controls.
Install the door control within sight of the door at a minimum
height of 5 feet (1.5 m) wheresmall children cannot reach,and
awayfrom the moving parts of the door.
NOTE:Forgang box installations it is not necessary to drill holes
or instafl the drywafl anchors. Use the existing holes in thegang
box (Figure 1).
WIRETHE DOORCONTROL(FIGURE2)
1. Strip 7/16 inch (11 mm) of insulation from oneend of the wire
and separatethe wires.
2. Connectone wire to eachof the two screws on the back of the
door control. The wires can be connectedto either screw.
Pre-wired installations:Choose anytwo wires to connect, but
make note of which wires are usedso that the correct wires are
connectedto the garage door opener in a later step.
MOUNTTHE DOORCONTROL(FIGURE3)
1. Mark the location of the bottom mounting holeand drill a 5/32
inch (4 mm) hole.
2. Install the bottom screw, allowing 1/8 inch (3 mm) to protrude
from the wall.
3. Position the bottom hole of the door control over the screw and
slide down into place.
4. Lift the push bar and mark thetop hole.
5. Removethe door control from the wall and drill a 5/32 inch
(4 mm) hole for the top screw.
6. Position the bottom hole of the door control over the screw and
slide down into place.Attach the top screw.
To prevent possible SERIOUSINJURYor DEATHfrom
electrocution:
• Besure power is NOTconnected BEFOREinstalling door
control.
• ConnectONLYto 12 VOLTlow voltage wires.
To prevent possible SERIOUSINJURYor DEATHfrom a closing
garagedoor:
• Install door control within sight of garagedoor, out of reach
of children at a minimum height of 5 feet (1.5 m), and away
from ALL moving parts of door.
• NEVERpermit children to operateor play with door control
push buttons or remote control transmitters.
• Activate door ONLYwhen it can be seenclearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYSkeepgarage door in sight until completely closed.
NEVERpermit anyoneto cross path of closing garage door.
HARDWARESHOWNACTUALSIZE
-Ni]i-7-Ni]-iN-q-fii>
Screw6ABx1-1/4"
(std installation)
(pre-wired)
Insulated
Staples
Drywall Anchors
Figure1
PRE-WIRED INSTALLATIONS:
Chooseany two wires to
connect, but make note of
which wires are used.
6-32x1"
e ire Screw
6-32x1"
Figure2 Figure3
Top Mounting Hole
Bell Wire
Terminal
Screws BottomMountingHole
Screw
6ABx1-1/4"
Screw
6ABx1-1/4"
22