Filter
Top Products
6500 Disk Array User’s Guide 21020690 B
Chapter 3 Display/Operation Panel
ARRAY OPTIONS Page 3 - 13
Clear Password
Clear a password as follows:
1. Press the down arrow, then press the right or left arrows until
is displayed.
2. Press the down arrow.
3. Press the right or left arrows until the menu is displayed.
4. Press the down arrow to view the menu. If
is displayed, press the right key once to show
5. Press the down arrow.
6. Press the right arrow once to display , then press SELECT. The
panel immediately displays , and password protection is
cleared from the array.
UNIT
ATTENTION
If your system cannot handle SCSI bus errors reported with a SCSI UNIT
ATTENTION signal, use this option to keep the array from doing so.
is typically set to . Setting to will
result in some error messages, such as Drive Failure and Reset, not being
reported over the SCSI bus. When active, an alarm will sound and a message
will display.
WRITE
PROTECT
Setting to prevents any data from being written to the
array. This is typically set to .
ALARM
This menu allows turning the audible alarm on and off. The audible alarm turns
on when any of the following conditions occur in the array:
• Disk drive fails
• Over-temperature sensor detects excessive heat
To silence the alarm temporarily when it is active, press any key to turn off the
alarm. The setting is typically set to .