Filter
Top Products
37
Motion Detecting Control Panel Setup
TIMER-TO-CLOSE (TTC)
NOTE: DO NOTenable TTCifoperating a one-
piece door.TTCisto be used ONLY with
sectional doors.
The TTC can be turned on or offand the time
interval can be adjusted to 1,5,and 10 minute
intervals.Once the TTC hasbeen setand the
door isopen,the selected close interval will blink
and begin to countdown to close the door.
Activate: Pressand hold the ONbutton until
one of the TTC LEDs lightup.
Then pressthe ON button again to cycle through
the time interval options(the corresponding TTC
LED will light for each time interval). The garage
door opener lightbulbswill blinkas
confirmation.
Deactivate:Pressand hold the OFF button until
all TTCLEDs turn offand a beep isheard from
the motor unit.
Temporarily holddoor open (suspendTTC):
Pressand release the HOLDOPEN button.
Pressthe HOLDOPENbutton again to resume
normal TTCoperation.
ON (TTC)
OFF (TTC)
HOLD OPEN
(TTC)
1 Minute,
5 Minute
and 10
Minute
TTC LED
LOCK
Activate:
Pressand hold the
LOCK button for 2
seconds.The
command LED will
flash aslong asthe
lockfeature is
activated and your
handheld remote
control will notoperate
your door atthistime.
Deactivate:
Pressand hold the
LOCK button again for
2 seconds.The
command LED will
stop flashing and
normal operation will
resume.
LOCK
Button
Command
LED
LIGHT
To change the amount of time the garage dooropenerlights willstay on:
Pressand hold the LOCK button until the garage door opener lightsflash.* The time interval isindicated
bythe number offlashes.
NUMBER OF TIMES GARAGE DOOR OPENER
LIGHTS FLASH
TIME THE GARAGEDOOR OPENER LIGHT
STAYS ON
1 11/2Minutes
2 21/2Minutes
3 31/2Minutes
4 41/2Minutes
To cycle through the time intervalsrepeatthe step above.
LIGHTFEATURE
Deactivate:
Pressand hold the LIGHTbutton until the garage door opener lights turn on,then offagain.*
Activate:
Startwith the garage door opener lightson.Pressand hold the LIGHT button until the garage door
opener lightsturn off, then on again.*
NOTE: Ifthe command LEDiscontinuouslyblinking,the LOCKfeature needs to be deactivated.
LOCK Button
LIGHT Button
Command LED
*Approximately 10 seconds
MOTIONSENSOR
Activate/Deactivate:
Slide the motion
sensor switch ONor
OFF.
Motion Sensor
Switch
Motion
Sensor
Door Control