Filter
Top Products
22
Install the Door Control
1.5 Position the bottomhole ofthe door
control over the screw and slide
down into place.
1.6 Lift the push bar up and markthe top hole. 1.7 Remove the door control from the wall
and drill a5/32 inch (4 mm) hole for
the top screw.
1.8 Position the bottomhole ofthe
door control over the screw and
slide down into place.Attach the
top screw.
DRYWALL
6ABx1-1/2"
Drywall Anchor
6-32x1"
GANG BOX
2 Wire the door control to the garage door opener
HARDWARE
Insulated Staple
PRE-WIREDINSTALLATIONS: When wiring
the door control to the garage door opener
make sure you use the same wires thatare
connected to the door control.
2.1
Run the white and red/white wire from the door control to
the garage door opener.Attach the wire to the wall and
ceiling with the staple (not applicable for gang boxor pre-
wired installations).Do not pierce the wire with the staple
asthismaycause ashort or an open circuit.
Staple
2.2
Strip 7/16 inch (11 mm) of insulation
fromthe end ofthe wire near the
garage door opener.
7/16"
(11 mm)
2.3
Connectthe wire to the red and
white terminalson the garage
door opener.To insertor
release wiresfromthe terminal,
push in the tab with screwdriver
tip.
RED
WHITE
WHITE
GREY