Filter
Top Products
Page 15.4
How to Set and Reset the Humidifier
Run-Time Alert
How to Set and Reset the Humidifier
Run-Time Alert
This counter keeps track of the number of days since the Service
Humidify icon was last reset; this icon will appear after the number of
days set in step #30 (below) has elapsed. Setting this counter to zero
in step #30 will prevent the Service Humidify icon from ever appearing.
Press the HUMIDITY button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
HUMIDITY
Press
Press
FAN
0
Service
Setup
I2
Humidify
0
Setup
30
Service
Humidify
Reset the counter to 0 to
remove the Service Humidify
icon from the display.
Adjust the number of days
in increments of 10 before
the Service Humidify icon
appears.
0 = Off
(0 - 1990 days)
Days since the last reset
of the Service Humidify
counter.
The humidifier run-time alert does not take the place of
any humidifier manufacturer’s recommended maintenance
plan; it only serves as a helpful reminder.
MODE
Press the MODE button repeatedly
until this setup screen appears.
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
HUMIDITY
MODE
MODE
Press the MODE button. While holding
the MODE, press the HUMIDITY button
to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
15