Filter
Top Products
Page 15.3
How to Set and Reset the UV Light
Run-Time Alert
How to Set and Reset the UV Light
Run-Time Alert
This counter keeps track of the number of days since the UV Light
counter has been reset. The UV Light icon will appear after the
number of days has been achieved, as shown in step #29 (below).
Setting the counter to zero in Step #29 will prevent the Service UV
Light icon from ever appearing.
Press the HUMIDITY button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
HUMIDITY
Press
(0 - 1990 days)
0
UV Light
Setup
29
Service
Reset the counter to 0 to
remove the Service UV
Light icon from the display.
Press
FAN
0
UV Light
Setup
I3
Service
Days since the UV Light
icon has been reset
Adjust the number of days
in increments of 10 before
the UV Light icon appears
on the display. 0 = off.
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
MODE
Press the MODE button repeatedly
until this setup screen appears.
HUMIDITY
MODE
MODE
Press the MODE button. While holding
the MODE, press the HUMIDITY button
to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
15