Filter
Top Products
Page 14.4
Dry Contact ProgrammingDry Contact Programming
UNOCCUPIED SETPOINTS - If Override is selected in step #24 (see
previous page), when the dry contact is energized the thermostat
will be forced into or out of Unoccupied setpoints. To adjust the
Unoccupied setpoints follow the setup steps below.
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
HUMIDITY
MODE
MODE
Press the MODE button. While holding
the MODE, press the HUMIDITY button
to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Press the HUMIDITY button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
HUMIDITY
Press
Unoccupied
Adjust the cooling
setpoint for unoccupied
periods.
(35 - 99, OF )
Unoccupied
Adjust the heating set-
point for Unoccupied
periods.
(OF, 35 - 99 )
Press
MODE
COOL
85
Setup
25
HEAT
55
Setup
26
14