Filter
Top Products
Press the HUMIDITY button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
HUMIDITY
Press
This display will track the number of hours that your thermostat has
been operating in the Override mode (see page 5.1). Press the FAN
button to reset the counter.
Press
FAN
Counts the number of
hours Override has
been active. Press FAN
to reset the Override Run-
Time counter.
Page 10.2
Viewing the Override Operation Run-TimeViewing the Override Operation Run-Time
Setup
Override
0
I i
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
10
HUMIDITY
MODE
MODE
Press the MODE button. While holding
the MODE, press the HUMIDITY button
to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.