Filter
Top Products
SELECTING A UTILITY STITCH
Utility Stitches
49
3
Selecting a Stitch Pattern
a
Turn on the machine, and then lightly press
the display.
→ Depending on the setting, either "1-01 Straight stitch
(Left)" or "1-03 Straight stitch (Middle)" is
automatically selected.
b
Press to display a screen
of the stitches in the selected category, and
then select a stitch pattern.
* If a different screen is displayed, press .
→ An image of the selected stitch pattern is displayed
below the symbol of the appropriate presser foot.
■ Using the Mirror Image Key
Press so that it appears as . A mirror
image of the selected stitch pattern is created.
Saving Stitch Settings
This machine is preset with the default settings for the
stitch width (zigzag width), stitch length, thread tension,
automatic thread cutting, automatic reverse/
reinforcement stitching, etc. However, if you wish to
save specific settings for a stitch so that they can be
used later, press after changing the settings to
save the new settings with the selected stitch.
Example: Using a stitch length of 2.0 mm for the
straight stitch
a
Select a straight stitch.
b
Set the stitch length to 2.0 mm.
c
Press .
* To reset the selected stitch pattern to its default
settings, press , and then press .
Memo
For details on the stitch patterns, refer to the “STITCH
SETTING CHART” at the end of this manual.
Note
If appears as after a stitch (buttonholes,
multi-directional sewing patterns, etc.) is selected, a
mirror image of the selected stitch cannot be created.
Memo
The default stitch length is 2.5 mm.