Filter
Top Products
ERROR MESSAGES
Appendix
183
8
ERROR MESSAGES
If the “Start/Stop button” or the “Reverse/Reinforcement Stitch” button is pressed before the machine is correctly set
up or if an incorrect operation is performed, the machine stops and informs you of the error with an alarm and an
error message. If an error message appears, correct the problem according to the instructions in the message.
(The message that is displayed can be cancelled either by pressing or performing the operation correctly.)
This message is displayed if a
malfunction occurred.
This message is displayed when
the “Start/Stop” button is pressed,
but the embroidery unit is not
attached.
This message is displayed when
the “Start/Stop” button is pressed
in embroidery mode, but the
embroidery frame is not attached.
This message is displayed when
there is a possibility that the data
for the selected pattern is
corrupted.
This confirmation message
appears after the machine is
turned on and the carriage of the
embroidery unit has moved to its
initial position.
This message is displayed when
the pattern selected in embroidery
mode is larger than the
embroidering area of the small
embroidery frame while the small
embroidery frame is attached.
This message is displayed when
there are too many characters to
be arranged in the curved
character configuration.
This message is displayed when
the pattern selected in embroidery
mode is larger than the
embroidering area of the large
embroidery frame while the small,
medium or large embroidery frame
is attached.