Filter
Top Products
ERROR MESSAGES
186
This message is displayed when
the bobbin thread is running out.
This message is displayed when
you try to retrieve a pattern
downloaded as one for a different
machine.
This message is displayed when
the bobbin is being wound, and the
motor locks because the thread is
tangled, etc.
This message is displayed when
the combined character pattern in
embroidery mode is too large for
the embroidery frame. You can
rotate the pattern 90 degrees to
continue combining characters.
This message is displayed when
the embroidery unit is initializing.
This message is displayed when
the combined character pattern in
embroidery mode is too large for
the embroidery frame.
This message is displayed when
the foot controller is pressed while
the embroidery unit is attached.
This message is displayed when
is pressed without an
embroidery card inserted.
This message is displayed when
the machine is turned on while the
needle is lowered and the
embroidery unit is attached.
This message is displayed when
the “Start/Stop” button is pressed
while the foot controller is
connected.