Filter
Top Products
Operation 35
© Travis Industries 4040830 100-01143
Before You Begin
• Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage,
bodily injury, or even death.
Location of Controls
Swing the control cover down to access the gas
control valve and pilot igniter.
Pilot Igniter
ON/OFF Switch
Flame Adjust Knob
Gas
Control
Valve
Gas Control Knob
An instruction card for operating
the fireplace is attached to the
inside of the fireplace here.
Replace it for easy reference.
Blower Control
The Pilot Flame can be
found below the back log.
Shut-Off Valve
Blower Knob This knob controls the speed of the internal convection blower that
pushes the heated air into the room.
On/Off Switch This control is used to turn the fireplace on and off.
Pilot Igniter The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark
directly next to the pilot, igniting the pilot flame.
Gas Control Knob This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of
the knob indicates the position this knob is in.
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The
pointer above the knob points to the position this knob is in.
Shut-Off Valve Turn the knob clockwise to shut gas off, counter-clockwise to turn gas on.
NOTE: this valve is used for installation and service, not for daily use.