17NetworkAIR ACPA4000
How to Use the Interface
All settings are controlled through the display interface located on the front of the equipment.
Turn on the equipment
After you plug in the power cord, the equipment immediately begins operation based on its last
programmed settings.
Note: The equipment waits three minutes before engaging the compressor if it has been
unplugged or has been off for less than three minutes.
Scrolling status screens
After start-up, the interface displays a screen that shows the firmware revision number. The display
interface then scrolls automatically and continuously through five screens of status information as
shown.
Press the up or down arrow key to interrupt the automatic scrolling and view a specific status screen.
Default schedule
is active
System Time:
Month-day year Time
System Status
Power: ON
Mode: Cool
Setpoint: 65 ° F
Temp & Humidity
Supply: 62 ° F
Return: 76 ° F
Remote: 75 ° F 13 %
No Active Alarms
System Time:
Month-day year Time
System Status
Blower: High
na1286a