Filter
Top Products
NetworkAIR ACPA400014
To connect an output relay:
1. Attach a 12-position terminal block (provided) to the output relay connector.
2. Strip the wire insulation on the sensor 6 mm (0.25 in) from the end.
3. Connect your sensor wires to the pins associated with one of the four positions on the output
relay connector.
4. Configure the settings for the output relay through the display interface.
See “Set Up Contacts and Relays” on page 26.
Input contacts
The figure below shows the four positions on the input contact connector and provides the individual pin
assignments for each position.
To connect an input contact:
1. Attach a 12-position terminal block (provided) to the input contact connector.
2. Strip the insulation of the wires you are connecting 6 mm (0.25 in) from the ends of the wires.
3. Connect the wires to pins associated with the appropriate position on the input contact connector.
4. Configure the settings for the input contacts through the display interface.
See “Set Up Contacts and Relays” on page 26.
GND
Signal
NO
GND
Signal
NO
GND
Signal
NO
GND
Signal
NO
na343a
User inputs 3
Remote
run/stop
User inputs 1
User inputs 2