Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
6
70444901
Preliminary Information
About the Control
This control is an advanced, programmable computer
that lets the owner control most machine features by
pressing a sequence of keypads.
The control allows the owner to program custom
cycles, run diagnostic cycles, and retrieve audit and
error information.
Tumblers shipped from the factory have default cycles
and other settings built in. The owner can change the
default cycle or any cycle.
IMPORTANT: It is extremely important that the
tumbler has a positive ground and that all
mechanical and electrical connections are made
before applying power to or operating the tumbler.
Power Failure Recovery
If a cycle is in progress when the power fails, and if
the power outage lasts three or more seconds, the cycle
is lost and cannot be resumed when power recovers. If
the power outage lasts less than three seconds, the
control will resume the cycle when the power
recovers.
Communications
The control has the ability to communicate with a
PDA and a laptop with an IrDA device running the
control software. Devices such as PDAs and laptops
that are IrDA capable (able to transmit information to
machine) that have been tested and approved for use
with the software can be used as a tool for managing
the machine.
Audit Information
The control collects and stores audit information,
which can be accessed with a PDA or PC. Refer to the
following list for some of the available audit
information. Refer to PC and PDA Application User
Instructions.
Total Number of Individual Cycle Counters
End of Cycle to Loading Door Open Time
End of Cycle to Start of Next Cycle Time
Total Number of Machine Cycles
Total Number of Operating Minutes
Power Failure Audit Data
The PDA or PC can receive audit and program data
from the control, and send programming data and
diagnostic commands to the control. Refer to PC and
PDA Application User Instructions for additional
information.
Some of the above listed audit data is available
manually. Refer to Collecting Audit Information
section.