Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
25
70444901
Collecting Audit Information
This feature allows the owner to retrieve audit
information stored in the tumbler by pressing a
sequence of pads on the control. For an explanation of
the audit options available, refer to the Audit Options
List on this page.
How to Enter Audit Feature
1. Control must be in Manual Mode to start. Refer
to Entering the Manual Mode.
2. Press the Up ( ) or the Down ( ) keypad until
“
” appears.
3. Press the Start ( ) keypad. “
” will
appear.
If the procedure did not work, the control will return to
the Idle Mode.
How to Read Audit Data
1. Use the Up ( ) or the Down ( ) keypad to scroll
through various options until the desired option is
shown in the display. Refer to the Audit Options
List, Table 2, for an explanation of the audit
options available.
2. Once the desired option appears in the display,
press the Start ( ) keypad once to start the
audit count.
3. Press the Start ( ) keypad again. The control
will go to the next audit option in the Audit
Options List.
4. To select other audit options, repeat steps 1 – 3.
How to Exit Audit Feature
Press the Back ( ) keypad until the control returns to
Idle Mode.
Audit Options List
Display Description
Total # of Machine Cycles
Total # of Run Hours
Total # of Heat Hours
Total # of Rapid Advance Cycles
Total # of Aborted Cycles
Total # of Times Anti-Wrinkle Exceeded
Average Time from End of Cycle to Door
Open (Last 25 Cycles)
Average Time from End of Cycle to Run
Mode (Last 25 Cycles)
Table 2