Filter
Top Products
23
SECTION I
Connector Assembly and Installation
Fig. I5
Fig. I6
4. SC CONNECTOR - HIGH DENSITY MATING
Installation
A. Clean the connector and coupling as described above.
B. Hold the connector by the boot.
C. Align the connector chamfers with the coupling (Fig. I5) and
push into place.
Removal
Note: This connector requires a tool to remove it from a
coupling.
A. Depress the buttons on the tool to raise pulling fingers.
B. Position tool prongs over connector and insert into the
coupling.
C. Release the buttons on the tool to engage the fingers and pull
firmly back to release the connector.
5. FC/PC3 CONNECTOR - MATING
Installation
A. Clean the connector and coupling as described above.
B. Engage the key in the slot while holding the connector by the
boot (Fig. I6). Make sure that the key remains engaged while
tightening the threaded nut.
Removal
A. To release the connector from the coupling, unscrew the
connector and cover all parts with dust caps.