MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming Procedures
Page 4-33Lines and Trunks
4
Outmode Signaling for Loop- or Ground-Start
Trunks 4
Use this procedure to identify either touch-tone signaling or rotary-dial signaling
for outgoing calls placed by using the specified loop- or ground-start trunk.
NOTE:NOTE:NOTE:
Since the factory setting is touch-tone, this procedure is not required if your
system has only touch-tone lines/trunks.
Summary: Outmode Signaling for Loop- or
Ground-Start Trunks 4
Programmable by System Manager
Mode Loop-Start: All; Ground-Start: Hybrid/PBX only
Idle Condition Not required
Planning Form Form 2c, System Numbering: Line/Trunk Jacks
Factory Setting Touch-tone
Valid Entries Touch-tone, Rotary
Inspect No
Copy Option Yes
Console Procedure To program a single line/trunk:
→ → →Select entry
mode
→Dial no. of line/trunk→ → → →
To program a block of lines/trunks:
→ → →Select block of lines/
trunks
→Toggle LED On/Off→ → → →
PC Procedure To program a single line/trunk:
→ → → →Type no. of the line/trunk→
→ → →
To program a block of lines/trunks:
→ → →Select block of lines/trunks→
Toggle letter On/Off→ → → →
