5-6
SelecType
Value
Selects the corresponding OneTouch mode
setting listed above this button if in OneTouch
mode 1 or 2, or selects the parameter available
within the current item, after entering the
SelecType mode menu.
Continue
Enables the printer to resume printing after
(Reset)
certain maintenance-required conditions or
errors have been cleared. If the
Continue
light is flashing, read the status or error
message on the display and correct the
problem as described in “Status and Error
Messages” on page 6-14. If used in
combination with the
ALT
button, the printer
is reset.
Form Feed
When the printer is off line and data remains
in the printer’s memory (Form Feed light is
on), prints out the data and clears the buffer.
When to Use SelecType
In general, use SelecType only for settings you cannot make in
your software, including the following:
❏
Changing the emulation modes and selecting the IES
(Intelligent Emulation switching) mode
❏
Specifying the channel and configuring the interface
❏
Choosing the size of the memory buffer used to receive data
You should keep in mind the following points when using
SelecType settings.
❏
A number of SelecType settings can also be made using the
OneTouch modes, printer driver.
