2-48
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
OL-29284-01, Release 6.x
Chapter 2 Configuring Interfaces
Verifying Interfaces Configuration
Mbits/s Frames Mbits/s Frames
-------------------------------------------------------------------------------
fc3/1 0 3871 0 3874
fc3/2 0 3902 0 4232
fc3/3 0 3901 0 4138
fc3/4 0 3895 0 3894
fc3/5 0 3890 0 3897
fc9/8 0 0 0 0
fc9/9 0 5 0 4
fc9/10 0 4186 0 4182
fc9/11 0 4331 0 4315
-------------------------------------------------------------------------------
Interface Input (rate is 5 min avg) Output (rate is 5 min avg)
----------------------------- -----------------------------
Rate Total Rate Total
Mbits/s Frames Mbits/s Frames
-------------------------------------------------------------------------------
port-channel 1 0 0 0 0
port-channel 2 0 3946 0 3946
Note The show interface transceiver command can only be issued on a switch in the Cisco MDS 9100 Series
if the SFP is present (see Example 2-10).
Example 2-10 Displays Transceiver Information
switch# show interface transceiver
fc1/1 SFP is present
name is CISCO-AGILENT
part number is QFBR-5796L
revision is
serial number is A00162193
fc-transmitter type is short wave laser
cisco extended id is unknown (0x0)
...
fc1/9 SFP is present
name is FINISAR CORP.
part number is FTRJ-1319-7D-CSC
revision is
serial number is H11A6ER
fc-transmitter type is long wave laser cost reduced
cisco extended id is unknown (0x0)
...
Example 2-11 displays the entire running configuration with information for all interfaces. The
interfaces have multiple entries in the configuration files to ensure that the interface configuration
commands execute in the correct order when the switch reloads.
Example 2-11 Displays the Running Configuration for All Interfaces
switch# show running-config
...
interface fc9/1
switchport speed 2000
...
interface fc9/1
switchport mode E
...
interface fc9/1
