3-45
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
OL-29284-01, Release 6.x
Chapter 3 Configuring Fibre Channel Interfaces
Configuration Examples for Fibre Channel Interfaces
BB state change notification supported
Maximum BB state change notifications 14
Rate Mode change supported
Rate Mode Capabilities Shared Dedicated
Receive BB Credit modification supported yes yes
FX mode Receive BB Credit (min/max/default) (1/32/32) (1/500/32)
ISL mode Receive BB Credit (min/max/default) -- (2/500/250)
Performance buffer modification supported no no
Out of Service capable yes
Beacon mode configurable yes
Extended B2B credit capable yes
Displaying SFP Diagnostic Information
You can use the show interface transceiver command to display small form-factor pluggable (SFP)
diagnostic information for Generation 2 switching modules.
switch# show interface transceiver
...
fc12/12 sfp is present
name is CISCO-FINISAR
part number is FTRJ-8519-7D2CS1
revision is A
serial number is H11TVQB
fc-transmitter type is short wave laser w/o OFC (SN)
fc-transmitter supports intermediate distance link length
media type is multi-mode, 62.5m (M6)
Supported speed is 200 MBytes/sec
Nominal bit rate is 2100 MBits/sec
Link length supported for 50/125mm fiber is 300 m(s)
Link length supported for 62.5/125mm fiber is 150 m(s)
cisco extended id is unknown (0x0)
no tx fault, rx loss, no sync exists, Diag mon type 104
SFP Diagnostics Information
Temperature : 24.33 Celsius
Voltage : 3.33 Volt
Current : 0.04 mA --
Optical Tx Power : N/A dBm --
Optical Rx Power : N/A dBm -
Note: ++ high-alarm; + high-warning; -- low-alarm; - low-warning
...
Configuration Examples for Fibre Channel Interfaces
This section describes example configurations and includes the following sections:
• Configuration Example for 48-Port 8-Gbps Module Interfaces, page 3-46
• Configuration Example for 24-Port 8-Gbps Module Interfaces, page 3-46
• Configuration Example for 4/44-Port 8-Gbps Module Interfaces, page 3-47
• Configuration Example for 48-Port 4-Gbps Module Interfaces, page 3-48
• Configuration Example for 24-Port 4-Gbps Module Interfaces, page 3-49
