Filter
Top Products
24 25
6. MEMORY
CLEAR
1. INSTALL
****
12:00 am
ENTER PIN
12:00 am
5. NEW PIN
1. INSTALL
****
12:00 am
ENTER PIN
12:00 am
Installation
Clearing the memory
Press either of the Menu up/down buttons (under the lid to the bottom right of the display).
The display then shows ENTER PIN (Personal Identifi cation Number) in the top line.
The default PIN is 0000, you’ll fi nd out later (page 24) how you can change this, but for
now press 0000 on the keypad (under the lid to the bottom right of the display). This clears
the top line and shows * for each number entered.
This takes you to the fi rst level of the menu at step 1. This is the INSTALLATION level. The
display looks like this:
Press an up or down menu button until you reach the MEMORY CLEAR menu, and then
press OK to go to the screen below (or press 6 to go into the MEMORY CLEAR menu ):
Press an up or down Menu button to select the desired sub-menu.
CLEAR ALL SENSORS
CLEAR ALL REMOTES
CLEAR ALL TIMERS
MASTER RESET
Select the desired sub-menu item and then press OK. Press Clear to back out of the
menu. You are asked to confi rm, 1. YES, 2 NO. Pressing 1 takes you back to the HOME
CONTROL screen. Pressing 2 stays in the MEMORY CLEAR menu. Note, selecting 4.
MASTER RESET immediately takes you back to the HOME CONTROL screen.
Installation
Changing your Personal Identifi cation Number (PIN)
Press either of the Menu up/down buttons (under the lid to the bottom right of the display).
The display then shows ENTER PIN (Personal Identifi cation Number) in the top line.
The default PIN is 0000, so press 0000 on the keypad (under the lid to the bottom right of
the display). This clears the top line and shows * for each number entered.
This takes you to the fi rst level of the menu at step 1. This is the INSTALLATION level. The
display looks like this:
Press an up or down menu button until you reach the NEW PIN menu, and then press OK
(or press 5 to go directly to the screen below):
Enter your new PIN (4 digits). Press OK.
Note, choose a PIN that you are not likely to forget (a birthday, for example). If you forget
your PIN you will not be able use the system. If you do forget your PIN contact www.x10.
com to fi nd out how to reset your system.
Press Clear to back out of the menu. If you press Clear while entering numbers, before
you’re fi nished setting the new PIN, it clears the numbers. If you press Clear after you’ve
set the new PIN and pressed OK, you are asked to confi rm, 1. YES, 2 NO. Pressing 1
takes you back to the HOME CONTROL screen. Pressing 2 stays in INSTALL mode.