Filter
Top Products
Tools Needed:
34
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Rear Support
31
Ratchet Wrench
1/2” Socket
1/2” Wrench
(2) Vice Clamps
Tape Measure
Level
Hammer
DOOR IN THE
UP POSITION
VERTICAL
TRACK
VICE
CLAMPS
DOOR EDGE
HORIZONTAL
TRACK
3/4”
KEEP HORIZONTAL TRACK PARALLEL
AND WITHIN 3/4” MAXIMUM OF DOOR
EDGE, OTHERWISE DOOR COULD FALL,
RESULTING IN SEVERE INJURY OR
DEATH.
Raise the door until the top section
and half of the next section are in a
horizontal position. Do not raise door
any further since rear of horizontal track
is not yet supported.
RAISING DOOR FURTHER CAN RESULT
IN DOOR FALLING AND CAUSE SEVERE
INJURY OR DEATH.
Clamp a pair of vice clamps on the
vertical tracks just above the second
roller on one side, just below the
second roller on the other side. This
will prevent the door from raising
or lowering while installing the rear
support.
Using perforated angle, (2) 5/16”-1 -
5/8” hex head lag screws and 5/16”
bolts with nuts (may not be supplied),
fabricate rear support for horizontal
tracks. Attach horizontal tracks to
the rear supports with 5/16”-18 x
1-1/4” hex bolts and nuts (may not be
supplied). Horizontal tracks must be
level and parallel with door.
NOTE: If rear supports are to be
installed over drywall, use (2) 5/16” x
2” hex head lagscrews.
NOTE: If an idrive
®
opener is installed,
position horizontal tracks one hole
above level when securing it to rear
supports. NOTE: 30” angle must be
attached to sound framing members
and nails should not be used.Now,
permanently attach the weather seal on
both door jambs and header
(Temporarily attached in PREPARING
THE OPENING on page 10). Avoid
pushing weather seal too tightly against
face of door.Now, lift door and check
it’s balance.
PRIOR TO WINDING OR MAKING
ADJUSTMENTS TO THE SPRINGS,
ENSURE YOU’RE WINDING IN THE
PROPER DIRECTION AS STATED IN
THE INSTALLATION INSTRUCTIONS.
OTHERWISE THE SPRING FITTINGS MAY
RELEASE FROM SPRING IF NOT WOUND
IN THE PROPER DIRECTION AND COULD
RESULT IN SEVERE OR FATAL INJURY.
WARNING
WARNING
WARNING