Filter
Top Products
Tools Needed:
32
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Cable Drum
No space between Ratchet
Pawl and Cable Drum
indicates engagement
Cable Drum
Ratchet Pawl
ENGAGED SIDE VIEW
No space b
etween
Ratchet Pawl and
Cable Drum
ENGAGED UNDERNEATH VIEW
Space b
etween Ratchet Pawl
and Cable Drum
non-indicates engagement
Cable Drum
Ratchet Pawl
DISENGAGED SIDE VIEW
No space between
Ratchet Pawl and
DISENGAGED U
NDERNEATH VIEW
UPPER POSITION
LOWER POSITION
LOWER POSITION SIDE VIEW
UPPER POSITION SIDE VIEW
Ratchet Pawl in Lower Position
Ratchet Pawl in Upper Position
Use these Illustration, in conjunction with the Instructions on the other side of
this label.
WARNING
Rachet Brack
e
t is under
EXTREME SPRING
TENSION
.
To avoid possible se
v
ere or
fatal injury,
DO NOT
remove
fasteners from ratchet bracket
until spring(s) are fully
wnwound.
To safely unwind spring(s)
read
and follow the directions in the
installation instructions/owners
manual.
DO NOT REMOVE T
HIS TAG.
31
Winding Springs
Ratchet
5/8” Socket
3” Extension
Gloves
RECOMMENDED SPRING TURNS
Door Height Spring Turns
6’-0” 14
6’-3” 14-1/2
6’-5” 15
6’-6” 15
6’-8” 15-1/2
6’-9” 15-1/2
7’-0” 16
7’-3” 16-1/2
7’-6” 17
7’-9” 17-1/2
8’-0” 18
END BRACKET
RATCHET
3”
EXTENSION
5/8” SOCKET
MARKS
None
To install drum wraps, position the left
hand drum wrap over the left hand
drum, align with counterbalance cable;
slide groove in drum wrap towards the
left until tabs snap over drum in
between drum and ratchet gear. Repeat
for right hand side.
IMPORTANT: RIGHT AND LEFT HAND
ARE ALWAYS DETERMINED FROM
INSIDE THE GARAGE LOOKING OUT.
Drum Wrap Installation
30
IT IS RECOMMENDED THAT LEATHER
GLOVES BE WORN WHILE WINDING
THE TORQUEMASTER
®
PLUS SPRINGS.
FAILURE TO WEAR GLOVES MAY CAUSE
INJURY TO HANDS.
Double check to ensure the
counterbalance cable is aligned in the
first groove of the cable drum Step 29.
Starting with the right hand side, place
a mark on winding shaft (or socket) and
end bracket.
Turn the pawl knob on the end bracket
to the upper position. (See page 33)
Using a ratchet wrench with a 5/8“
socket (NOTE: A 3” extension is also
recommended for added clearance from
the horizontal angle.), wind the spring
by rotating the winding shaft counter
clockwise, while watching the mark on
the winding shaft.
WARNING
DRUM WRAP
(LEFT HAND)
DRUM
(LEFT HAND)
GROOVE
IN DRUM
TABS
COUNTERBALANCE
CABLE
PRIOR TO WINDING OR MAKING ADJUSTMENTS TO THE SPRINGS, ENSURE
YOU’RE WINDING IN THE PROPER DIRECTION AS STATED IN THE INSTAL-
LATION INSTRUCTIONS. OTHERWISE THE SPRING FITTINGS MAY RELEASE
FROM SPRING IF NOT WOUND IN THE PROPER DIRECTION AND COULD
RESULT IN SEVERE OR FATAL INJURY.
WARNING