Filter
Top Products
Tools Needed:
20
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Attaching Horizontal Track to
Adjustable Flagangle
NOTE: If quick install flagangles were
installed in Step 14, skip this step and
continue with Step 16. If not, complete
this step.
To install horizontal track, place the
curved end over the top roller. Align the
bottom of the horizontal track with the
vertical track. Hand tighten the horizontal
track to the flagangle with (2) 1/4” - 20 x
9/16” large head ribbed track bolts and
(2) 1/4”-20 flange hex nuts.
DO NOT RAISE DOOR UNTIL HORIZONTAL
TRACKS ARE SE CURED AT REAR, AS
OUTLINED IN STEP 30, OR DOOR COULD
FALL FROM OVERHEAD POSI TION
CAUSING SEVERE OR FATAL INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in
the flagangle using (1) 3/8” - 16 x 3/4”
truss head bolt and (1) 3/8” - 16 hex
nut. Repeat for other side. Remove the
nail that was temporarily holding the top
section in place, installed in Step 13.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE TO
TOP SECTION.
NOTE: If an idrive
®
opener will be installed,
position horizontal tracks slightly above
level.
15
7/16” Socket
9/16” Socket
Ratchet Wrench
9/16” Wrench
Level
Flat Tip
Screwdriver
1/4”-20 FLANGE
HEX NUTS
FLAGANGLE
1/4” - 20 X 9/16”
LARGE HEAD
RIBBED TRACK
BOLTS
WARNING
3/8” - 16 X 3/4”
TRUSS HEAD BOLT
3/8” - 16 HEX NUT
HORIZONTAL TRACK
HORIZONTAL ANGLE