Filter
Top Products
Tools Needed:
7
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Installation
Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb and the header level. Side
clearance, from edge of door to wall, must be minimum of 3-1/2” (89mm) on each side.
IMPORTANT: STAINLESS STEEL OR PT 2000 COATED LAG SCREWS (NOT SUPPLIED) MUST BE USED WHEN INSTALLING CENTER BEARING
BRACKETS, END BRACKETS, JAMB BRACKETS, OPERATOR MOUNTING/SUPPORT BRACKETS AND DISCONNECT BRACKETS ON TREATED
LUMBER (PRESERVATIVE-TREATED). STAINLESS STEEL OR PT 2000 LAG SCREWS ARE NOT NECESSARY WHEN INSTALLING PRODUCTS ON
UNTREATED LUMBER.
NOTE: It is recommended that 5/16” lag screws be pilot drilled using a 3/16” drill bit prior to fastening.
IMPORTANT: WHEN INSTALLING 5/16” DIAMETER LAG SCREWS USING AN ELECTRIC DRILL/DRIVER, THE DRILL/DRIVER’S CLUTCH MUST BE
SET TO DELIVER NO MORE THAN 200 IN. LBS. OF TORQUE. FASTENER FAILURE COULD OCCUR AT A HIGHER SETTING.
NOTE: Insulated glass will cause the top section to be significantly heavier than the remaining sections. Wayne-Dalton attempts to balance the door at
the top & bottom. To prevent any sudden door acceleration between the top & bottom, we recommend motor operating all glazed top doors. Doors with
insulated glass top sections should not be manually operated.
Attaching Flagangles to Vertical
Tracks
(2) 1/4”- 20 FLANGE
HEX NUTS
If you have fully adjustable flagangles:
Hand tighten the flagangle to the vertical
track using a stud plate and (2) 1/4” - 20
flange hex nuts. Repeat for other side.
Secure the flange nuts after flagangle
spacing is completed in Step 11.
If you have quick install flagangles:
Place the lower quick install tab of the
flagangle in the quick install feature of the
vertical track. Give the flagangle 1/4 turn to
lock in place. Repeat for other side.
FLAGANGLE
STUD PLATE
VERTICAL TRACK
None
1
FLAGANGLE
VERTICAL
TRACK
FULLY ADJUSTABLE FLAGANGLE
QUICK INSTALL FLAGANGLE
QUICK INSTALL TAB UNLOCKED
QUICK INSTALL TAB LOCKED