Filter
Top Products
Tools Needed:
Tools Needed:
19
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Place vice clamps onto both vertical tracks
just above the third Roller. This is to prevent
the garage door from raising while winding
torsion spring(s).
FAILURE TO PLACE VICE CLAMPS ONTO
VERTICAL TRACK CAN ALLOW DOOR TO
RAISE AND CAUSE SEVERE OR FATAL
INJURY.
Securing Door
for Spring Winding
(2) Vice Clamps
WARNING
19
Starting on the right side, adjust the cable
drum assembly by rotating the drum until
the set screw faces directly away from the
header. Torque tube cam peak should be
pointing straight up.
Loosen the set screw no more than 1/2 turn.
Ensure counterbalance cable is aligned and
seated in the first and second grooves and
pull on the end of the counterbalance cable
to remove all cable slack.
Snug the set screw, and then tighten an
additional1-1/2 turns. Measure
approximately 6” of cable and cut off excess
cable. Insert end of cable in hole of cable
drum.
Repeat for left hand cable drum assembly.
IMPORTANT: ENSURE THE CABLE IS
ALIGNED AND SEATED IN THE FIRST
AND SECOND GROOVES OF THE CABLE
DRUM PRIOR TO WINDING SPRING
S.
NOTE: This illustration shows the right hand
TorqueMaster® Plus cable drum assembly,
left hand cable drum assembly is
symmetrically opposite.
20
Cable Adjustment
Vice Grips
Pliers/Wire
Cutters
Flat Tip
Screwdriver
Step Ladder
TRACK
VICE CLAMPS
ATTACHED TO
TRACK
PLACE VICE
CLAMPS ABOVE
3RD ROLLER
6”
CUT CABLE
HERE
CAM PEAK
STRAIGHT UP
FIRST AND
SECOND GROOVE
SET SCREW