Filter
Top Products
Tools Needed:
14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Attaching Horizontal Tracks to
Flagangles
If you have fully adjustable flagangles:
To install horizontal track, place the curved
end over the top roller. Align the bottom of
the horizontal track with the vertical track.
Hand tighten the horizontal track to the
flagangle with (2) 1/4”-20 x 9/16” track
bolts and (2) 1/4” - 20 flange hex nuts.
Repeat for other side.
DO NOT RAISE DOOR UNTIL
HORIZONTAL TRACKS ARE SE-
CURED AT REAR, AS OUTLINED
IN STEP 23, OR DOOR COULD
FALL FROM OVERHEAD POSI-
TION CAUSING SEVERE OR FATAL
INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in the
flagangle using (1) 3/8” - 16 x 3/4” truss
head bolt and (1) 3/8” - 16 hex nut. Repeat
for other side.
NOTE: If an idrive
®
opener will be installed,
position horizontal tracks slightly above level.
Remove the nail that was temporarily
holding the top section in place, installed in
Step 11.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE TO
TOP SECTION.
If you have quick install flagangles:
Align key slot of the horizontal track with
the quick install tab of the flagangle. Push
curved portion of horizontal track down to
lock in place.
DO NOT RAISE DOOR UNTIL
HORIZONTAL TRACKS ARE SE-
CURED AT REAR, AS OUTLINED
IN STEP 23, OR DOOR COULD
FALL FROM OVERHEAD POSI-
TION CAUSING SEVERE OR FATAL
INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in the
flagangle using (1) 3/8” - 16 x 3/4” truss
head bolt and (1) 3/8” - 16 hex nut. Repeat
for other side.
NOTE: If an idrive
®
opener will be installed,
position horizontal tracks slightly above level.
Remove the nail that was temporarily
holding the top section in place, installed in
Step 11.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE TO
TOP SECTION.
12
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
Step Ladder
WARNING
1/4”-20 FLANGE
HEX NUTS
FLAGANGLE
1/4”-20 X 9/16”
TRACK BOLTS
3/8” - 16 X 3/4”
TRUSS HEAD BOLT
3/8” - 16 HEX NUT
HORIZONTAL TRACK
HORIZONTAL ANGLE
VERTICAL TRACK
HORIZONTAL TRACK
WARNING
KEY SLOT
QUICK
INSTALL
TAB
HORIZONTAL
TRACK
VERTICAL
TRACK
FLAGANGLE
KEY SLOT
QUICK
INSTALL
TAB
HORIZONTAL
TRACK
VERTICAL
TRACK
FLAGANGLE
FULLY ADJUSTABLE FLAGANGLES
QUICK INSTALL FLAGANGLES