Filter
Top Products
Tools Needed:
12
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
IF NO U-BAR IS INSTALLED
(6) 1/4”-20 X 11/16”
SELF DRILLING
SCREWS
OPERATOR BRACKET
CENTERED IN THE
MIDDLE OF TOP SECTION
SIDE VIEW
OPERATOR
BRACKET
ALIGNED WITH
TOP OF SECTION
9
Power Drill
7/16” Socket
Driver
Tape Measure
Operator Bracket
IMPORTANT: WHEN CONNECTING A
TROLLEY TYPE GARAGE DOOR OPENER
TO THIS DOOR, A WAYNE-DALTON
OPENER/TROLLEY BRACKET MUST
BE SECURELY ATTACHED TO THE TOP
SECTION OF THE DOOR, ALONG WITH
ANY U-BARS PROVIDED WITH THE
DOOR. THE INSTALLATION OF THE
OPENER MUST BE ACCORDING TO
MANUFACTURER’S INSTRUCTIONS AND
FORCE SETTINGS MUST BE ADJUSTED
PROPERLY.
NOTE: For retro fit applications, the operator
bracket must be aligned with an existing
operator.
If no u-bar is installed:
Locate the center of the top section and
attach the operator bracket as shown in the
illustration using (6) 1/4” – 20 x 11/16” self
drilling screws.
NOTE: Prior to fastening operator bracket to
top section, ensure the top edge of operator
bracket is aligned with the top edge of the
section as shown on far right
If u-bar is installed:
Remove, but retain (4-6) 1/4”-14 x 7/8”
self drilling screws from the center of the
u-bar, allowing the operator bracket to slide
between the section and the u-bar.
Locate the center of the top section and
slide operator bracket under u-bar till the
operator bracket is seated against the u-bar
flange.
NOTE: Prior to fastening operator bracket to
top section, ensure the top edge of operator
bracket is aligned with the top edge of the
section as shown on far right.
Attach the operator bracket using
(6) 1/4” – 20 x 11/16” self drilling screws
(as shown). Finish re-attaching the u-bar
using the self tapping screws removed
previously.
OPERATOR
BRACKET
OPERATOR
BRACKET
U-BAR
U-BAR
1/4”-14 X 7/8” SELF
DRILLING SCREWS
SIDE VIEW OF U-BAR
U-BAR
OPERATOR BRACKET IN
PLACE UNDER U-BAR
( 6) 1/4”-20 X 11/16”
SELF DRILLING
SCREWS
SIDE VIEW OF U-BAR WITH
OPERATOR BRACKET INSTALLED
OPERATOR
BRACKET
U-BAR
TOP OF
SECTION
TOP EDGE OF
OPERATOR
BRACKET
IF U-BAR IS INSTALLED