Filter
Top Products
Tools Needed:
22
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
23
Ratchet Wrench
1/2” Socket
1/2” Wrench
(2) Vice Clamps
Tape Measure
Level
Hammer
PERFORATED
ANGLE
(3) 5/16”
NUTS
(3) 5/16”
BOLTS
Rear Support
DOOR IN THE
UP POSITION
VERTICAL
TRACK
VICE
CLAMPS
Raise the door until the top section and half
of the next section are in a horizontal position.
Do not raise door any further since rear of
horizontal track is not yet supported.
RAISING DOOR FURTHER CAN
RESULT IN DOOR FALLING AND
CAUSE SEVERE OR FATAL INJURY.
Clamp a pair of vice clamps on the vertical
tracks just above the second roller on one
side, just below the second roller on the other
side. This will prevent the door from raising or
lowering while installing the rear support.
Using perforated angle, (2) 5/16”-1 - 5/8” hex
head lag screws and 5/16” bolts with nuts
(may not be supplied), fabricate rear support
for horizontal tracks. Attach horizontal tracks
to the rear supports with 5/16”-18 x 1-1/4”
hex bolts and nuts (may not be supplied).
Horizontal tracks must be level and parallel to
the door within 3/4” to 7/8” maximum of door
edge.
KEEP HORIZONTAL TRACK
PARALLEL AND WITHIN 3/4” TO
7/8” MAXIMUM OF DOOR EDGE,
OTHERWISE DOOR COULD FALL,
RESULTING IN SEVERE OR FATAL
INJURY.
IMPORTANT: DO NOT SUPPORT THE
WEIGHT OF THE DOOR ON ANY PART OF
THE HORIZONTAL TRACK HANGER THAT
CANTILEVERS 4” OR MORE BEYOND A
SOUND FRAMING MEMBER.
NOTE: If rear supports are to be installed over
drywall, use (2) 5/16” x 2” hex head lag screws.
NOTE: If an idrive
®
opener is installed, position
horizontal tracks one hole above level when
securing it to rear supports.
NOTE: 30” angle must be attached to sound
framing members and nails should not be
used.
Now, permanently attach the weather seal
on both door jambs and header (Temporarily
attached in PREPARING THE OPENING on page
6). Avoid pushing weather seal too tightly against
face of door.
PRIOR TO WINDING OR MAKING
ADJUSTMENTS TO THE SPRINGS, ENSURE
YOU’RE WINDING IN THE PROPER DIRECTION
AS STATED IN THE INSTALLATION
INSTRUCTIONS. OTHERWISE THE SPRING
FITTINGS MAY RELEASE FROM SPRING IF
NOT WOUND IN THE PROPER DIRECTION AND
COULD RESULT IN SEVERE OR FATAL INJURY.
WARNING
WARNING
3/4” to 7/8”
Horizontal tracks
Door edges
3/4” to 7/8”
WARNING